Moulding Kit HK HT HG Bonnet & Fenders Inc Clips
Moulding Kit HK HT HG Bonnet & Fenders Inc Clips

Holden Moulding Kit HK HT HG Bonnet & Fenders Inc Clips

M1010

 $270.42 PR

Quality ISO 9001 certified system

There is no substitute for 40 years' experience! That's why Rare Spares guarantee both the quality & fitment of their products!

Moulding kit which is for the bonnet (hood) and guard (fender) of the vehicle.

This kit has the bonnet, eye brow mouldings and fitting rivets and clips.

1 # bonnet moulding, 1 # Left, 1 # Right eye brow moulding, 22 moulding clips, 22 rivets for the body panels, 2 flat washers and 2 Self tappers.

1 # to fit the rivets to the bonnet and guards size the rivets before drilling, make sure that the holes are clear then use a pop rivet gun to apply the rivets into the panels, fit the clips to the rivets by placing the clip over the head of the rivet then push the clip sideways to lock the clip to the rivet.

2 # Push the end clips, flat side to the bonnet into the bonnet moulding, use the bonnet to line the clips to the holes in the bonnet before fitting the moulding to the bonnet.

3 # where possible hook the moulding under the clips, then push the moulding over the clips so that the moulding sits against the panel, then fit the washers and screws to bonnet moulding tighten until the scew head just touches the washer against the bonnet.

This product suits Holden HK, HT and HG

 

  • Belmont, Kingswod, Premier, Brougham
  • Sedan, Wagon, Utility (Ute), Panel Van
  • Fitted with 6 cylinder Red motor, 161, 186, 8 cylinder V8 253 (4.2 Litre), 308 (5.0 Litre), Chevrolet, 307, 327, 350 engine.

This part suits the following :