Brake rotor screw set which is for the disc brakes of the vehicle
Please note: This disc brake rotor screw set screws the brake disc to the wheel hub
Note: If replacing the disc rotor clean the hub of any rust before fitting the disc rotor to the hub to avoid disc run out.
If replacing only the bolts replace one bolt at a time apply Loctite to the thread, give the bolts a liberal coating making sure that they are covered completely around the thread, then put the bolt back in, tighten it up and move to the next one, follow a star pattern when tightening the bolts to get an even fitting.
Loctite is not supplied with bolts.
This product suits Holden HD, HR
- Standard, Special, Premier
- Sedan, Wagon, Utility (Ute), Panel Van
- Fitted with 6 cylinder, 149,179, 161, 186, engine.