Brake hose which fits front and rear brakes of the vehicle.
Please note: This brake hose screws into the front brake wheel cylinder then up to the metal bracket on the sub frame which is held in place by the U shaped clip, then the metal brake line screws into the hose.
The rear the hose screws into the brass fitting on the diff and up to the metal brake pipe which is held in place by a U shaped metal clip, then the brake pipe screws into the end of the hose
Note: The hose for the front wheel cylinder uses a copper brake washer to seal against the cylinder and are not supplied with the hose.
This product suits Holden 48, FJ, FE and FC
- Standard, Special
- Sedan, Wagon, Utility (Ute), Panel Van
- Fitted with 6 cylinder Grey motor engine.